After successful completion of the course, students are able to establish simulation models starting from machine equations and power electronics block diagrams. Students will further be able to test and verify these simulation models based on simulation results taken at rspecific operating points.
Documentation only offert in German
Simulation is done either based on pre-fabricated drive models or by development of individual models. Simulation language is Matlab/Simulink.
The individual steps and milestones during the development of the model as well as verification is checked and discussed continuously and in addition has to be documented.
über TISS oder bei der Vorbesprechung Ort: persönlich
The student must have at least 1 of the course(s) completed listed below:
Lecture notes for this course are available. Sekretariat des Instituts E370-2