322.047 Applied Fluid Mechanics Laboratory
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2018W, LU, 2.0h, 2.5EC, to be held in blocked form

Properties

  • Semester hours: 2.0
  • Credits: 2.5
  • Type: LU Laboratory Exercise

Aim of course

Introduction to various important fluid flows and measurement methods in fluid mechanics.

Subject of course

Units of 4 hours each on the following topics: (i) viscosimetry, (ii) pipe flow, (iii) classical optical measurement methods, free convection; shallow water channel, (iv) icing of a wing profile in the subsonic wind tunnel (hot wire anemometry, 6-component force balance), (v) Particle Image Velocimetry or Laser Doppler Anemometry, (vi) diffusion and fingering in a Hele-Shaw cell.

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Wed14:00 - 14:3010.10.2018 Seminar room BA 7th floorPlanning meeting: fixing of dates
Wed14:00 - 17:3031.10.2018 Fluid mechanics laboratoryParticle image velocimetry, Laser Doppler anemometry
Wed14:00 - 17:3014.11.2018 Fluid mechanics laboratoryViscosimetry
Wed14:00 - 17:3028.11.2018 Fluid mechanics laboratorySubsonic wind tunnel
Wed14:00 - 17:3005.12.2018 Fluid mechanics laboratoryHele-Shaw cell
Wed14:00 - 17:3012.12.2018 Institute of Science and Technology, KlosterneuburgPipe flow
Wed14:00 - 17:3019.12.2018 Fluid mechanics laboratoryShallow water channel, optical measurement methods, natural convection
Course is held blocked

Examination modalities

At the begin of each unit the knowledge of the lecture notes isexamined . During the lab, reports are written which are collected at the end of each unit. The marks are based on the knowledge of the lab contents, on active participation and on the reports.

Exams

DayTimeDateRoomMode of examinationApplication timeApplication modeExam
Wed - 20.01.2021assessed14.10.2020 13:00 - 19.01.2021 23:59TISSZeugnis

Course registration

Begin End Deregistration end
25.09.2018 15:00 31.10.2018 12:00 31.10.2018 18:00

Curricula

Study CodeSemesterPrecon.Info
033 245 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
033 282 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

Course materials can be found in the tuwel-course 322.047 Labor Angewandte Fluidmechanik.

 

Miscellaneous

  • Attendance Required!

Language

German