317.543 Analytical Methods in Lightweight Design
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2023S, LU, 2.0h, 2.0EC

Properties

  • Semester hours: 2.0
  • Credits: 2.0
  • Type: LU Laboratory Exercise
  • Format: Hybrid

Learning outcomes

After successful completion of the course, students are able to:

  • to design a lightweight structure by application of the knowledge from LVA „317.542 VU Analytical Methods in Lightweight Design“
  • to operate the hard- and software to measure force, displacement, and strain
  • to perform (under supervision) the ultimate load experiment

 

Subject of course

Laboratory exercises for advanced training. Design/calculation/manufacture/testing of a 3D printed thin-walled plastic lightweight structure.

Teaching methods

Working in groups of three to four students.

Application of the knowledge from LVA „317.542 VU Analytical Methods in Leightweight Design“ to design a thin-walled lightweight structure.

3D printing of the lightweight structure.

Introduction to measurement hardware and software; independent creation of the measurement report.

Testing of the lightweight structure and discussion of the failure modes with all LVA students.

Preparation of a multi-part written report.

Mode of examination

Immanent

Additional information

 

 

 

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Tue14:00 - 15:0007.03.2023GM 4 Knoller Hörsaal - VT Vorbesprechung
Thu08:00 - 12:0009.03.2023GM 8/9 - Hörsaal des Internationalen Wiener Motorensymposiums Einführungsveranstaltung
Wed08:00 - 10:0003.05.2023Seminarraum BE 01 Messtechnik EInführung
Wed08:00 - 10:0017.05.2023Seminarraum BE 01 Messtechnik EInführung

Examination modalities

Collaboration and written report on the design, manufacture, measurement and testing of the lightweight structure.

Course registration

Begin End Deregistration end
06.02.2023 08:00 07.03.2023 08:00 29.03.2023 08:00

Curricula

Study CodeSemesterPrecon.Info
033 245 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
033 282 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase
066 434 Materials Sciences
066 445 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
066 482 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

No lecture notes are available.

Previous knowledge

Knowledge in solid mechanics and Engineering Design (CAD).

Preceding courses

Miscellaneous

  • Attendance Required!

Language

German