315.729 Automotive Powertrains
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2019W, LU, 2.0h, 2.0EC

Properties

  • Semester hours: 2.0
  • Credits: 2.0
  • Type: LU Laboratory Exercise

Learning outcomes

After successful completion of the course, students are able to:

  • describe the structure and function of an engine test bench
  • calculate the heat release of a combustion cycle from corresponding measurement results

Subject of course

Introduction in the cylinder pressure indication of internal combustion engines.

  • Purpose of the cylinder pressure indication
  • Measuring technique
  • Measuring procedure
  • Analysis of the measured values

Carrying out of a measure on the engine test bench

Processing and analysis of the measured values

Writing of a protocol

Teaching methods

Lecture on the laboratory exercise with explanation of calculation and evaluation methods. Carrying out measurements on the engine test bench.

 

Mode of examination

Immanent

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Tue09:00 - 09:3001.10.2019GM 8/9 - Hörsaal des Internationalen Wiener Motorensymposiums Vorbesprechung KFZ-Antriebe LU
Thu10:00 - 12:0017.10.2019GM 8/9 - Hörsaal des Internationalen Wiener Motorensymposiums Vorlesung zur Laborübung KFZ-Antriebe
Thu10:00 - 12:0031.10.2019GM 8/9 - Hörsaal des Internationalen Wiener Motorensymposiums Eingangstest zur Laborübung KFZ-Antriebe
Thu10:00 - 12:0014.11.2019 Treffpunkt: Foyer Obj. 227 Arsenal Science Center, Franz Grill Straße 8Laborübung Gruppe 1
Thu13:00 - 15:0014.11.2019 Treffpunkt: Foyer Obj. 227 Arsenal Science Center, Franz Grill Straße 8Laborübung Gruppe 2
Thu15:00 - 17:0014.11.2019 Treffpunkt: Foyer Obj. 227 Arsenal Science Center, Franz Grill Straße 8Laborübung Gruppe 3

Examination modalities

Entrance test, participation in the practical laboratory exercise, writing of a protocol.

Course registration

Begin End Deregistration end
01.09.2019 08:00 30.09.2019 12:00 30.09.2019 12:00

Curricula

Study CodeSemesterPrecon.Info
033 245 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
033 282 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase
066 445 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
066 482 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

Lecture notes are available.

Previous knowledge

Requirements: Students need to be proficient in the subject "Automotive Powertrains" (lecture no. 315.728) in order to be admitted to the course.

Miscellaneous

Language

German