311.110 Testing of Production Equipment
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2021S, LU, 2.0h, 2.0EC

Properties

  • Semester hours: 2.0
  • Credits: 2.0
  • Type: LU Laboratory Exercise
  • Format: Distance Learning

Learning outcomes

After successful completion of the course, students are able to explain and demonstrate the standards and procedures for acceptance, inspection and calibration as well as the analysis and evaluation of the geometric inspection of manufacturing equipment.

Subject of course

The following points receive special attention:- application of laser interferometry - determination of positioning accuracy - influence of environmental conditions - checking of parallelism and perpendicularity - application of calibration artefacts

Teaching methods

Active participation and collaboration in the laboratory operation in the performance of a verification process and application of calibration methods according to international standards.

Mode of examination

Immanent

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Tue09:00 - 15:0015.06.2021 Zoom Meeting- Link wird ausgesendet (LIVE)Laborübung - Überprüfen von Fertigungseinreichungen

Examination modalities

Discussion of a measurement process and measurement protocol.

Course registration

Begin End Deregistration end
11.05.2021 08:00 08.06.2021 23:59 14.05.2021 23:59

Curricula

Study CodeSemesterPrecon.Info
066 445 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
066 482 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

No lecture notes are available.

Language

if required in English