302.681 Hydraulic Machinery and Hydraulic Systems I
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2020S, LU, 2.0h, 2.0EC

Properties

  • Semester hours: 2.0
  • Credits: 2.0
  • Type: LU Laboratory Exercise

Learning outcomes

After successful completion of the course, students are able to take measurements on hydraulic machines (pumps and turbines) at the test facility. This applies to the main parameters such as pressure, flow, torque, speed and special measurements.

Subject of course

measurement of pump characteristic and efficiency of a pelton turbine

Teaching methods

Introduction to the use of the measuring software Labview, creation of a measurement program and measurement in the laboratory

Mode of examination

Immanent

Lecturers

Institute

Examination modalities

Creation of a measurement protocol.

Course registration

Begin End Deregistration end
03.03.2020 15:00 23.03.2020 23:00 23.03.2020 23:00

Registration modalities:

Anmeldung erfolgt bei der Vorbesprechung

Curricula

Study CodeSemesterPrecon.Info
033 245 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
033 282 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase
066 445 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
066 482 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

No lecture notes are available.

Miscellaneous

  • Attendance Required!

Language

German