302.675 Hydraulic Measuring and Testing
This course is in all assigned curricula part of the STEOP.
This course is in at least 1 assigned curriculum part of the STEOP.

2020S, UE, 2.0h, 2.0EC

Properties

  • Semester hours: 2.0
  • Credits: 2.0
  • Type: UE Exercise

Learning outcomes

After successful completion of the course, students are able to take measurements on hydraulic machines (pumps and turbines) at the test facility. This applies to the main parameters such as pressure, flow, torque, speed and special measurements.

Subject of course

Application of the measuring methods and measuring instruments for hydraulic plants, measuring rules and regulations during acceptance test.

Teaching methods

Introduction to the use of the measuring software Labview. Performing measurements in the laboratory.

Mode of examination

Immanent

Lecturers

Institute

Course dates

DayTimeDateLocationDescription
Tue15:00 - 16:0003.03.2020GM 3 Vortmann Hörsaal Vorbesprechung
Tue13:00 - 17:0009.06.2020 - 23.06.2020Seminarraum O221-1 Käfer
Hydraulic Measuring and Testing - Single appointments
DayDateTimeLocationDescription
Tue03.03.202015:00 - 16:00GM 3 Vortmann Hörsaal Vorbesprechung
Tue09.06.202013:00 - 17:00Seminarraum O221-1 Käfer
Tue16.06.202013:00 - 17:00Seminarraum O221-1 Käfer
Tue23.06.202013:00 - 17:00Seminarraum O221-1 Käfer

Examination modalities

Creation of a measuring program with practical implementation of the measurement.

Course registration

Begin End Deregistration end
12.03.2020 00:00 28.04.2020 00:00 28.04.2020 00:00

Curricula

Study CodeSemesterPrecon.Info
066 445 Mechanical Engineering STEOP
Course requires the completion of the introductory and orientation phase
066 482 Mechanical Engineering - Management STEOP
Course requires the completion of the introductory and orientation phase

Literature

No lecture notes are available.

Miscellaneous

  • Attendance Required!

Language

German